SeaKlear PRS is a patented, two-stage system proven to enhance filtration in pools, spas and hot tubs. SeaKlear PRS has been reviewed and determined by the EPA to effectively trap Cryptosporidium in the filter thereby reducing outbreak risk.

Benefits of SeaKlear PRS:

• Reduces waters turbidity and recovery time, especially during peak bather loads
• Enhances filtration down to 0.5 micron
• Traps algae, Cryptosporidium and E. coli in the filter
• Proven to reduce 99.9% of Cryptosporidium from pool water

1. Make sure the filter is clean and equipment is working properly.
2. Using a time-metered pump or by hand, add PRS Stage 1 per the recommended dosage.
3. 6 hours after adding Stage 1, add PRS Stage 2 per the recommended dosage, using a time-metered pump or by hand.

In Case of Accidental Fecal Release:

1. Evacuate the pool.
2. Remove all visible fecal material possible.
3. Follow local health department guidelines for proper disinfection.
4. To trap remaining particles, Cryptosporidium, E. coli, and Giardia, treat the pool with PRS in the following manner:
5. Add stage 1 by dispersing it throughout the pool at 4 oz. per 20,000 gallons.
6. 30 Minutes after adding Stage 1, add Stage 2 at 4 oz. per 20,000 gallons.
7. Do not add Stage 1 and Stage 2 at the same time.
8. Monitor the filter pressure at regular intervals.
9. Backwash the filter after proper CT disinfection value is achieved.

Stage 1:

• 4 oz. per 20,000 gal.

Stage 2:

• 4 oz. per 20,000 gal.

Frequency:

Low Bather Load:

• Weekly

Medium Bather Load:

• 2 to 4 times weekly

High Bather Load:

• Daily